LS3 Engine Mounts - Pfadt
I ended up using Pfadt engine mounts to support my engine. I was planning on using the new C6 Corvette mounts, but when I installed them along with my Kooks headers, the clearance between the mount and the header was only about 1/8", and that just seemed to darn close. Especially since it was the mount rubber, not metal, that was close. You can see it in the picture. And I know that it looks like the mount is upside-down, but that's the way the little index tabs actually fit. Anyway, Shane mentioned he had just used a set of Pfadt mounts, and Lord knows, if it's good enough for Shane than it's good enough for me. Only thing I ran into was that the lower mount bolts (mount to chassis) were not threaded their entire length, so I cut a small piece of aluminum to act as a giant spacer/washer. With the Pfadt mounts there is plenty of room for the Kooks headers, and a nice performance kick to boot!
Last updated 10/24/2010
Last updated 10/24/2010